| |
|
|
G
H
- hald, description, Changes and Improvements to Removable Media Management
- High Sierra file system, Disk-Based File Systems
- /home (automounted), Automounting or AutoFS
- hot-plugging
- (overview), Dynamic Reconfiguration and Hot-Plugging
- adding a SCSI device to a SCSI bus (how to), SPARC: How to Add a SCSI Device to a SCSI Bus
- adding PCI adapter card (how to), How to Add a PCI Adapter Card
- configuring a SCSI controller (how to), How to Configure a SCSI Controller
- configuring a SCSI device (how to), How to Configure a SCSI Device
- configuring a USB device (how to), How to Configure a USB Device
- connecting a SCSI controller (how to), SPARC: How to Connect a SCSI Controller
- disconnecting a SCSI controller with cfgadm command (how to), How to Disconnect a SCSI Controller
- logically connecting a USB device (how to), How to Logically Connect a USB Device
- logically disconnecting a USB device (how to), How to Logically Disconnect a USB Device
- logically disconnecting a USB device subtree (how to), How to Logically Disconnect a USB Device Subtree
- PCI devices (overview), PCI or PCIe Hot-Plugging With the cfgadm Command
- removing a SCSI device (how to), SPARC: How to Remove a SCSI Device
- removing PCI adapter card (how to), How to Remove a PCI Adapter Card
- replacing an identical SCSI device on a SCSI controller (how to), SPARC: How to Replace an Identical Device on a SCSI Controller
- unconfiguring a SCSI device (how to), How to Unconfigure a SCSI Controller
- unconfiguring a USB device (how to), How to Unconfigure a USB Device
- HSFS, See High Sierra file system
I
- I/O, direct, UFS Direct Input/Output (I/O)
- identifying
- devices, How to Display System Configuration Information
- disks on a system (how to), How to Identify the Disks on a System
- primary USB audio device (how to), How to Identify Your System's Primary Audio Device
- inconsistencies in file systems, Why UFS File System Inconsistencies Might Occur
- incorrect . and .. entries, Data Blocks
- incremental backup
- Choosing the Type of Backup
- Purpose of the /etc/dumpdates File
- (example of), How to Back Up a File System to Tape
- indirect blocks, Indirect Blocks
- InfiniBand devices
- adding a VPPA communication service (how to), How to Add a VPPA Communication Service
- configuring an IB Port, HCA_SVC, or a VPPA device (how to), How to Configure a IB Port, HCA_SVC, or a VPPA Device
- configuring an IB pseudo device (how to), How to Configure an IB Pseudo Device
- configuring an IOC device (how to), How to Configure an IOC Device
- displaying (how to), How to Display IB Device Information
- displaying IB communication services (how to), How to Display IB Communication Services
- displaying kernel IB clients of an HCA (how to), How to Display Kernel IB Clients of an HCA
- dynamic reconfiguration (overview), Dynamically Reconfiguring IB Devices (cfgadm)
- overview, Overview of InfiniBand Devices
- removing an existing IB port, HCA_SVC, or a VPPA communication service (how to), How to Remove an Existing IB Port, HCA_SVC, or a VPPA Communication Service
- unconfiguring an IB Port, HCA_SVC, or a VPPA (how to), How to Unconfigure an IB Port, HCA_SVC, or a VPPA Device
- unconfiguring an IB pseudo device (how to), How to Unconfigure an IB Pseudo Device
- unconfiguring an IOC device (how to), How to Unconfigure an IOC Device
- unconfiguring IB devices connected an HCA (how to), How to Unconfigure IB Devices Connected to an HCA
- updating an IOC configuration (how to), How to Update an IOC Configuration
- updating the IP p_key tables (how to), How to Update the IB p_key Tables
- initiators
- iSNS, display status, CLI, How to Display the Status of Clients
- iSNS, managing, CLI, Managing the iSNS Server and Clients
- inode list size, Superblock Checks
- inode states, Inodes
- inodes, Inodes
- bad number, Data Blocks
- block special, Inodes
- character special, Inodes
- checking format and type, Inodes
- directory, Inodes
- FIFO, Inodes
- link count, Inodes
- number of bytes per, Number of Inodes (Files)
- regular, Inodes
- size, Inodes
- symbolic link, Inodes
- installboot command, SPARC: How to Install a Boot Block on a System Disk
- installgrub command, x86: How to Install a Boot Block on a System Disk
- installing a boot block (how to), SPARC, SPARC: How to Install a Boot Block on a System Disk
- Internet Storage Name Service, See iSNS
- iSCSI
- (overview), The iSCSI Technology (Overview)
- accessing iSCSI disks (how to), Accessing iSCSI Disks
- configuring iSCSI target discovery (how to), How to Configure iSCSI Target Discovery
- configuring unidirectional or bidirectional CHAP authentication for (how to), How to Configure CHAP Authentication for Your iSCSI Initiator
- general iSCSI error messages, General iSCSI Error Messages
- modifying iSCSI initiator and target parameters (how to), How to Modify iSCSI Initiator and Target Parameters
- monitoring your iSCSI configuration (how to), Monitoring Your iSCSI Configuration
- preparing for a Solaris iSCSI configuration (how to), How to Prepare for a Solaris iSCSI Configuration
- removing discovered iSCSI targets (how to), How to Remove Discovered iSCSI Targets
- software and hardware requirements, Solaris iSCSI Software and Hardware Requirements
- static and dynamic target discovery, Configuring Dynamic or Static Target Discovery
- troubleshooting iSCSI configuration problems (how to), Troubleshooting iSCSI Configuration Problems
- iscsiadm add command, adding static or dynamic targets (example of), How to Configure iSCSI Target Discovery
- iscsiadm list, displaying ISCSI configuration information (example of), Monitoring Your iSCSI Configuration
- iscsiadm modify command
- enabling CHAP (example of), How to Configure CHAP Authentication for Your iSCSI Initiator
- enabling or disabling static or dynamic targets (example of), How to Remove Discovered iSCSI Targets
- iscsiadm remove command, removing static or dynamic targets (example of), How to Remove Discovered iSCSI Targets
- iSNS
- clients, The iSNS Technology (Overview)
- configuring failover, Configuring High Availability of iSNS Server Using Sun Cluster
- default discovery domain, The iSNS Technology (Overview)
- display client status, How to Display the Status of Clients
- display initiator status, How to Display the Status of Clients
- display target status, How to Display the Status of Clients
- managing clients, Managing the iSNS Server and Clients
- managing initiators, Managing the iSNS Server and Clients
- managing targets, Managing the iSNS Server and Clients
- nodes, The iSNS Technology (Overview)
- proxy resource, Configuring High Availability of iSNS Server Using Sun Cluster
- Sun Cluster, Configuring High Availability of iSNS Server Using Sun Cluster
- technology overview, The iSNS Technology (Overview)
- iSNS server
- configuring, Configuring the iSNS Server
- configuring, CLI, Using the Command Line Interface to Configure iSNS
- disabling, How to Disable the iSNS Server Daemon
- discovery domain
- adding, CLI, How to Add a Discovery Domain to a Discovery Domain Set
- assigning clients, CLI, How to Assign Clients to a Discovery Domain
- creating, CLI, How to Create the Discovery Domains
- displaying status, CLI, How to Display the Status of a Discovery Domain
- removing, CLI, How to Remove a Discovery Domain from a Discovery Domain Set
- removing a client, How to Remove a Client from a Discovery Domain
discovery domain set
- creating, CLI, How to Create the Discovery Domain Sets
- disabling, CLI, How to Disable a Discovery Domain Set
- displaying status, CLI, How to Display the Status of a Discovery Domain Set
- removing, How to Remove a Discovery Domain Set
display settings, How to Display the Current Server Configuration
- enable, disable server state notifications, How to Set Notifications for Changes in Server State
- enabling, How to Enable the iSNS Server Daemon
- enabling default discovery domain set, How to Enable the Default Discovery Domain Set
- set retry threshold, How to Set the Number of Retries for Client Inquiries
- specify data store location
- The iSNS Technology (Overview)
- How to Specify the Data Store Location
- How to Specify the Data Store Location
- ISO 9660 file system, Disk-Based File Systems
- ISO standards, 9660 CD format, Guidelines for Accessing Removable Media Data
|
|
|
|
|
