RHEL 6 Storage Admin - 13.8. Advanced RAID Device Creation

Red Hat Enterprise Linux 9 Essentials Book now available.

Purchase a copy of Red Hat Enterprise Linux 9 (RHEL 9) Essentials

Red Hat Enterprise Linux 9 Essentials Print and eBook (PDF) editions contain 34 chapters and 298 pages

13.8. Advanced RAID Device Creation

In some cases, you may wish to install the operating system on an array that can't be created after the installation completes. Usually, this means setting up the /boot or root file system arrays on a complex RAID device; in such cases, you may need to use array options that are not supported by Anaconda. To work around this, perform the following procedure:

Insert the install disk as you normally would.
During the initial boot up, select Rescue Mode instead of Install or Upgrade. When the system fully boots into Rescue mode, the user will be presented with a command line terminal.
From this terminal, use parted to create RAID partitions on the target hard drives. Then, use mdadm to manually create raid arrays from those partitions using any and all settings and options available. For more information on how to do these, refer to Chapter 4, Partitions, man parted, and man mdadm.
Once the arrays are created, you can optionally create file systems on the arrays as well. Refer to Section 2.2, “Overview of Supported File Systems” for basic technical information on file systems supported by Red Hat Enterprise Linux 6.
Reboot the computer and this time select Install or Upgrade to install as normal. As Anaconda searches the disks in the system, it will find the pre-existing RAID devices.
When asked about how to use the disks in the system, select Custom Layout and click Next. In the device listing, the pre-existing MD RAID devices will be listed.
Select a RAID device, click Edit and configure its mount point and (optionally) the type of file system it should use (if you didn't create one earlier) then click Done. Anaconda will perform the install to this pre-existing RAID device, preserving the custom options you selected when you created it in Rescue Mode.

Note

The limited Rescue Mode of the installer does not include man pages. Both the man mdadm and man md contain useful information for creating custom RAID arrays, and may be needed throughout the workaround. As such, it can be helpful to either have access to a machine with these man pages present, or to print them out prior to booting into Rescue Mode and creating your custom arrays.