RHEL 6 Deployment - 6.3. Configuring a DHCP Client

Red Hat Enterprise Linux 9 Essentials Book now available.

Purchase a copy of Red Hat Enterprise Linux 9 (RHEL 9) Essentials

Red Hat Enterprise Linux 9 Essentials Print and eBook (PDF) editions contain 34 chapters and 298 pages

6.3. Configuring a DHCP Client

To configure a DHCP client manually, modify the /etc/sysconfig/network file to enable networking and the configuration file for each network device in the /etc/sysconfig/network-scripts directory. In this directory, each device should have a configuration file named ifcfg-eth0, where eth0 is the network device name.

The /etc/sysconfig/network-scripts/ifcfg-eth0 file should contain the following lines:

DEVICE=eth0
BOOTPROTO=dhcp
ONBOOT=yes

A configuration file is needed for each device to be configured to use DHCP.

Other options for the network script includes:

DHCP_HOSTNAME — Only use this option if the DHCP server requires the client to specify a hostname before receiving an IP address. (The DHCP server daemon in Red Hat Enterprise Linux does not support this feature.)
PEERDNS=<answer> , where <answer> is one of the following:
- yes — Modify /etc/resolv.conf with information from the server. If using DHCP, then yes is the default.
- no — Do not modify /etc/resolv.conf.

If you prefer using a graphical interface, refer to Chapter 5, Network Configuration for instructions on using the Network Administration Tool to configure a network interface to use DHCP.

Tip

For advanced configurations of client DHCP options such as protocol timing, lease requirements and requests, dynamic DNS support, aliases, as well as a wide variety of values to override, prepend, or append to client-side configurations, refer to the dhclient and dhclient.conf man pages.