Sometimes it is necessary to add more swap space after installation. For
example, you may upgrade the amount of RAM in your system from 128 MB to
256 MB, but there is only 256 MB of swap space. It might be advantageous
to increase the amount of swap space to 512 MB if you perform
memory-intense operations or run applications that require a large
amount of memory.
You have three options: create a new swap partition, create a new swap
file, or extend swap on an existing LVM2 logical volume. It is
recommended that you extend an existing logical volume.
To extend an LVM2 swap logical volume (assuming
/dev/VolGroup00/LogVol01 is the volume you want
to extend):
Disable swapping for the associated logical volume:
# swapoff -v /dev/VolGroup00/LogVol01 |
Resize the LVM2 logical volume by 256 MB:
# lvm lvresize /dev/VolGroup00/LogVol01 -L +256M |
Format the new swap space:
# mkswap /dev/VolGroup00/LogVol01 |
Enable the extended logical volume:
Test that the logical volume has been extended properly:
To add a swap volume group (assuming
/dev/VolGroup00/LogVol02 is the swap volume
you want to add):
Create the LVM2 logical volume of size 256 MB:
# lvm lvcreate VolGroup00 -n LogVol02 -L 256M |
Format the new swap space:
# mkswap /dev/VolGroup00/LogVol02 |
Add the following entry to the /etc/fstab file:
/dev/VolGroup00/LogVol02 swap swap defaults 0 0 |
Enable the extended logical volume:
Test that the logical volume has been extended properly:
To add a swap file:
Determine the size of the new swap file in megabytes and
multiply by 1024 to determine the number of blocks. For example, the
block size of a 64 MB swap file is 65536.
At a shell prompt as root, type the following command with
count being equal to the desired block size:
dd if=/dev/zero of=/swapfile bs=1024 count=65536 |
Setup the swap file with the command:
To enable the swap file immediately but not automatically at
boot time:
To enable it at boot time, edit /etc/fstab
to include the following entry:
/swapfile swap swap defaults 0 0 |
The next time the system boots, it enables the new swap
file.
After adding the new swap file and enabling it, verify it is
enabled by viewing the output of the command cat
/proc/swaps or free.
