Recovering From Disk Set Problems
The following sections detail how to recover from specific disk set related problems.
What to Do When You Cannot Take Ownership of A Disk Set
In cases in which you cannot take ownership of a disk set
from any node (perhaps as a result of a system failure, disk failure,
or communication link failure), and therefore cannot delete the disk set record, it
is possible to purge the disk set from the Solaris Volume Manager state
database replica records on the current host.
Purging the disk set records does not affect the state database information contained
in the disk set, so the disk set could later be imported
(with the metaimport command, described at Importing Disk Sets).
If you need to purge a disk set from a Sun Cluster
configuration, use the following procedure, but use the -C option instead of the -P
option you use when no Sun Cluster configuration is present.
How to Purge a Disk Set
- Attempt to take the disk set with the metaset command.
# metaset -s setname -t -f
This command will attempt to take (-t) the disk set named setname forcibly
(-f). If the set can be taken, this command will succeed. If the
set is owned by another host when this command runs, the other host
will panic to avoid data corruption or loss. If this command succeeds, you
can delete the disk set cleanly, without the need to purge the set.
If it is not possible to take the set, you may purge ownership
records.
- Use the metaset command with the -P to purge the disk set from
the current host.
# metaset -s setname -P
This command will purge (-P) the disk set named setname from the
host on which the command is run.
- Use the metaset command to verify that the set has been purged.
# metaset
Example 25-5 Purging a Disk Set
host1# metaset -s red -t -f
metaset: host1: setname "red": no such set
host2# metaset
Set name = red, Set number = 1
Host Owner
host2
Drive Dbase
c1t2d0 Yes
c1t3d0 Yes
c1t8d0 Yes
host2# metaset -s red -P
host2# metaset
See Also
