6.1. Displaying existing IPv6 addresses
First you should check, whether and which IPv6 addresses are already configured (perhaps auto-magically during stateless auto-configuration).
6.1.1. Using "ip"
Usage:
# /sbin/ip -6 addr show dev <interface> |
Example for a static configured host:
# /sbin/ip -6 addr show dev eth0
2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_ fast qlen 100
inet6 fe80::210:a4ff:fee3:9566/10 scope link
inet6 2001:0db8:0:f101::1/64 scope global
inet6 fec0:0:0:f101::1/64 scope site |
Example for a host which is auto-configured
Here you see some auto-magically configured IPv6 addresses and their lifetime.
# /sbin/ip -6 addr show dev eth0
3: eth0: <BROADCAST,MULTICAST,PROMISC,UP> mtu 1500 qdisc pfifo_fast qlen
� 100
inet6 2002:d950:f5f8:f101:2e0:18ff:fe90:9205/64 scope global dynamic
valid_lft 16sec preferred_lft 6sec
inet6 3ffe:400:100:f101:2e0:18ff:fe90:9205/64 scope global dynamic
valid_lft 2591997sec preferred_lft 604797sec inet6 fe80::2e0:18ff:fe90:9205/10
� scope link |
6.1.2. Using "ifconfig"
Usage:
# /sbin/ifconfig <interface> |
Example (output filtered with grep to display only IPv6 addresses). Here you see different IPv6 addresses with different scopes.
# /sbin/ifconfig eth0 |grep "inet6 addr:"
inet6 addr: fe80::210:a4ff:fee3:9566/10 Scope:Link
inet6 addr: 2001:0db8:0:f101::1/64 Scope:Global
inet6 addr: fec0:0:0:f101::1/64 Scope:Site |
