These installation instructions assume
Commands are Unix-compatible.
The source path is /var/tmp, other paths are possible.
Installations were tested on Red Hat Linux 6.1 and 6.2.
All steps in the installation will happen in super-user account root.
PostgreSQL version number is 6.5.3
These are the Package(s) and available here:
There are certain prerequisites before compiling the PostgreSQL program, you must verify that egcs-c++-version.i386.rpm package is installed on your system. The egcs-c++-version.i386.rpm package
is located in you Red Hat Linux CD-ROM under RedHat/RPMS subdirectory. After compilation and installation of PostgreSQL you can remove this package from your system.
To verify that egcs-c++-version.i386.rpm is already installed, use the following command:
[root@deep] /# rpm -q egcs-c++
|
To install egcs-c++-version.i386.rpm, use the following command:
[root@deep] /# mount /dev/cdrom /mnt/cdrom
[root@deep] /# cd /mnt/cdrom/RedHat/RPMS
[root@deep ]/RPMS# rpm -Uvh egcs-c++-version.i386.rpm
|
egcs-c++ ##################################################
|
Before you decompress the tarballs, it is a good idea to make a list of files on the system before you install it, and one afterwards, and then compare them using diff to find out what file it placed where. Simply run find /* > PostgreSQL1
before and find /* > PostgreSQL2 after you install the tarball, and use diff PostgreSQL1 PostgreSQL2 > PostgreSQL-Installed to get a list of what changed.
To Compile you need to decompress the tarball -tar.gz:
[root@deep] /# cp postgresql-version.tar.gz /var/tmp
[root@deep] /# cd /var/tmp
[root@deep ]/tmp# tar xzpf postgresql-version.tar.gz
|
