Tcp-wrappers shoud be enabled to start and stop the sshd2 server. Upon execution, inetd reads its configuration information from a configuration file which, by default, is /etc/inetd.conf. There
must be an entry for each field of the configuration file, with entries for each field separated by a tab or a space.
Edit the inetd.conf file, vi/etc/inetd.conf and add the line:
ssh stream tcp nowait root /usr/sbin/tcpd sshd -i
:
The -i parameter is important since it specifies that sshd is being run from inetd. Also, update your inetd.conf file by sending a SIGHUP signal, killall -HUP inetd
after adding the above line into the file.
To update your inetd.conf file, use the following command:
[root@deep] /#killall -HUP inetd
Edit the hosts.allow file, vi/etc/hosts.allow and add the line:
sshd: 192.168.1.4 win.openna.com
Which means client 192.168.1.4 with host name win.openna.com is allowed to ssh on the server.
Note:
These daemon strings for tcp-wrappers are in use by sshd2:
sshd, sshd2
The name sshd2 was called with usually sshd.
sshdfwd-X11
if you want to allow/deny X11-forwarding.
sshdfwd-<port-number>
for tcp-forwarding.
sshdfwd-<port-name>
port-name defined in /etc/services. Used in tcp-forwarding.
:
If you do decide to switch to using ssh, make sure you install and use it on all your servers. Having ten secure servers and one insecure is a waste of time.
