On Velox (101.31) lilo fails because the disk is too big.
Use lilo -L (or add lba32 to /etc/lilo.conf),
then:
# lilo -L
Added 2.2.18pre21 *
# dd if=/dev/sda of=/root/bootsect.lnx bs=512 count=1
# mcopy /root/bootsect.lnx a:
# lilo -u /dev/sda
# reboot (into NT)
|
Then as above in Section 12.5 to update the MS/Windows/NT
boot loader.
Remember: Be sure to run the lilo command after you
update /etc/lilo.conf or the changes will not be in effect.
Copyright © 1995-2006 [email protected]
|