Ensure X forwarding is enabled, and log in as user oracle:
Start the oracle installer:
cd /tmp/Disk1
./runInstaller
|
If everything is working you should see a stream test pass, and a window
will pop up. If not, go back and make sure you didn't miss anything.
It is safe to ignore two rpm errors in the console.
With older versions of the libaio
package installed (seems
like the unstable version does not have this problem) two compile
errors arise but can be ignored (in the GUI--just click continue).
The two errors concern ``ihsodbc ctx_on'' and ``all_no_orcl.''
Before running /home/oracle/product/10.1.0/Db_1/root.sh as
root create a symbolic link:
Now run the root.sh script.
Pre 10.2 Oracle installed a service called cssd. The script
waits 600 seconds (10 minutes) for the service to be started before
going on. You need to do some set up while it waits for you! The
message on the console will show: Expecting the CRS daemons to
be up within 600 seconds. There are three things to do (as
suggested by Eduardo Diaz Comellas).
First, the /etc/inittab file needs a line to set the active
runlevels to 23 (the Debian defaults) instead of 35 (the Red Hat and Suse
defaults). Change it from:
h2:35:respawn:/etc/init.d/init.cssd run >/dev/null 2>&1 </dev/null
|
to
h2:23:respawn:/etc/init.d/init.cssd run >/dev/null 2>&1 </dev/null
|
Next, the inittab runs /etc/rc.d/init.d/init.cssd. Exit this
script and, at
line 83, replace:
with
The Debian su does not support the -l option.
Finally, make init restart the service:
The root.sh script should now continue and finish as expected.
Copyright © 1995-2006 [email protected]
|