| Subcommand |
Description |
Comments |
call <phonenumber> |
Simulate an inbound phone call from <phonenumber>. |
|
accept <phonenumber> |
Accept an inbound call from <phonenumber> and change the call's state "active". |
You can change a call's state to "active" only if its current state is "waiting" or "held". |
busy <phonenumber> |
Close an outbound call to <phonenumber> and change the call's state to "busy". |
You can change a call's state to "busy" only if its current state is "waiting". |
cancel <phonenumber> |
Terminate an inbound or outbound phone call to/from <phonenumber>. |
|
data <state> |
Change the state of the GPRS data connection to <state>. |
Supported <state> values are:
unregistered -- No network available
home -- On local network, non-roaming
roaming -- On roaming network
searching -- Searching networks
denied -- Emergency calls only
off -- Same as 'unregistered'
on -- same as 'home' |
hold |
Change the state of a call to "held". |
You can change a call's state to "held" only if its current state is "active" or "waiting". |
list |
List all inbound and outbound calls and their states. |
|
voice <state> |
Change the state of the GPRS voice connection to <state>. |
Supported <state> values are:
unregistered -- No network available
home -- On local network, non-roaming
roaming -- On roaming network
searching -- Searching networks
denied -- Emergency calls only
off -- Same as 'unregistered'
on -- Same as 'home' |
status |
Report the current GSM voice/data state. |
Values are those described for the voice and data commands. |
